HOW-TO / TIPS

Ghost Shrimp - Steelhead Candy!
Empty StarsSign in to rate this!
Ghost Shrimp - Steelhead Candy!
There are a lot of products out they’re being sold to entice a fisherman to make a purchase that promises results in catching the elusive Steelhead. All sorts of hardware like spinners, spoons, wobblers, and artificial worms of many colors, artificial looking roe, and fly representations. The list just goes on. All those methods have been proven producers in catching steelhead. The most successful that’s not often allowed is natural bait. We have earthworms, roe of many different salmonoid species. The salmon roe can be clustered, or used single, or in roe bags. The rare bait is the Ghost Shrimp. Not rare because they are few, rare because most avid fishermen know little of them. Where they can be found, how they can be caught, how to preserve them, keeping them alive, and how to present them to steelhead. They are just as mysterious as the steelhead themselves. They are often called bugs or steelhead candy due to the fact that fish can’t resist them. Sandy beaches, estuaries, and muddy bays are a good place to look for them. They will be in the intertidal, especially middle intertidal range.

Attachment:
Plans to make are on the web sites
Attachment:
Little volcanos



They will not be located at the average high tide level of the beach area but usually within 2-4 foot drop from highest-level tide average. They love muddy sand and you can recognize their burrow entrances as they appear like small volcano’s. Ghost Shrimp can be found most often on the sandy beaches of western British Columbia and the east coast of Vancouver Island all the way down to California. The best method is to pump them out of the sand with what is called a slurp pump or Ghost Shrimp pump when the sand is saturated with water. This allows the shrimp to be easily drawn out of the sand with the water and sand when you pump for them. Ghost shrimp burrows can be full of mazes and easily three feet in depth or deeper. My favorite time is just when the water comes off the burrows. The sand and burrows are soft and of course with the water being drawn out, sand and shrimp will flow with it. When the Ghost Shrimp pump is placed in the center of the burrow and then pushed in while the handle is being drawn up - this creates suction that will draw sand, water and shrimp. Sometime two or three attempts is required. I have a bait box tied to my waist with a paper towel soaked in salt water that offers quick storage while I continue to pump more out of the sand. Remember to peruse the burrows that you dug up as the Ghost Shrimp will come out of their collapsed burrows or ones that are missed in the discarded sand will climb out. Of all the shrimp that I find, I don’t keep males, those that are to small, and females with eggs are put back under cover so the birds will not eat them. This allows the shrimp beds to continue to flourish. Once I collect what I need I rinse all the sand off them and store them in a clean plastic bucket on a bed of paper towel soaked in seawater with another paper towel over them - the bucket is then stored at the bottom of the fridge. I use them the next day but if delayed you must remove all damaged or dying shrimps, as they will poison the rest with decay.

Attachment:
Male is pale and female is red
Ghost shrimp can grow up to 4 1/2 inches but I favor using the small red females.

The males are the largest and are white. Be careful of the large claw when handling them. The claw power is capable to apply a mean bite and can draw blood. When collecting them I will occasionally keep ten males with their large pinchers removed. In British Columbia the maximum you can have on you is 50 and you have to have a salt water fishing license. Now for steelhead larger does not mean better. I favor 2 – 2 1/2 inches in length.

These crustaceans actually belong to the crab family and are a delicacy to many types of fish in the ocean - salmon and steelhead included. Ghost Shrimp are often a favorite of surf casters fishing in California.

Attachment:
Fine wire does the trick
Keeping them on the hook is the most challenging skill. Some will use spider wrap, rubber bands, egg loop knots, and sew the hook through the tail. They are very delicate and you can loose them easily on a cast.

The best proven method for me is a very thin copper wire that I wrap around the tail of the shrimp together with the fishing line keeping it straight and firm with the hook that is embedded lightly through the thorax using a #4 Gamagatsu hook. Ghost Shrimp are great on their own but I will often fish a lil corky or bead sliding above the tail on the main line. The corky will hold the ghost shrimp above the bottom and the bead lets it sink faster.

I will often lengthen my leader to the float long. I want to see the float indicate the weight is bouncing on the bottom.

Attachment:
Double header on Ghost Shrimps



Often the hit is when I let the float swing in the current. Another event is when the float indicates my weight is touching the bottom I will lightly pick up the line and move the float to avoid hanging up on the bottom. This little action on the ghost shrimp also seems to induce a strike from the steelhead. This method though does create hang-ups and that is why I use 10 lb. or 12 lb. leaders for an easy break off. One of the most interesting thing that occurs is if I think I had a hit and upon retrieving my line I notice that the head of the shrimp is gone - that confirms it was a steelhead! I will immediately throw out the oozing tail that is left and often they will hit again.


Like0 | Dislike0 (3620 views)
Comments (0)Show all comments

Latest Articles

Find out more about our Fishing Tournament Service - FishingDerbyOnline.com
Find us on Facebook Follow us on Twitter